Elgato Wave Mic Arm LP

Elgato Wave Mic Arm LPis intended for desk setups where the microphone needs to stay close without sitting high in front of the operator. According to the source material, it uses a two-section low-profile boom arm design, supports podcasting, streaming, and broadcasting, and attaches to the desk with a padded C-clamp.

The 29.1″ / 740 mm horizontal reach gives the arm enough distance to work around monitors, keyboards, and small control surfaces. Anyone who has worked at a tight desk knows that a tall microphone arm can quickly get in the way. Keeping the arm low makes the setup easier to use without moving the microphone out of reach.

Highlights

• Low-profile boom arm for podcasting, streaming, and broadcasting
• 29.1″ / 740 mm horizontal reach
• 360 horizontal rotation at the base and elbow
• 90 up / 60 down arm rotation
• Integrated cable management for cleaner routing
• Supports microphones up to 4.4 lb / 2 kg

Quick Specs & Uses

• Product type: Two-section low-profile boom arm
• Horizontal reach: 740 mm / 29.1 in
• Lower arm desk clearance: 70 mm / 2.8 in
• Upper arm desk clearance: 160 mm / 6.3 in
• Horizontal rotation: 360 at base and elbow
• Vertical rotation: 90 up / 60 down at elbow
• Mounting type: C-clamp surface mounting
• Desk clamp range: Up to 60 mm / 2.4 in
• Top thread: 1/4″-20
• Adapters: 3/8″ and 5/8″
• Cable management: Integrated cable management
• Internal springs: Yes
• Maximum load: 2 kg / 4.4 lb including microphone and accessories

Why It Helps

Desk space disappears quickly once a microphone, monitor, keyboard, and audio interface are all in place. A low-profile arm keeps the microphone available for speaking while leaving the front of the desk easier to work around.

The integrated cable management is useful for the same reason. Instead of leaving the microphone cable hanging across the desk or down the side of the arm, the cable can be routed through the arm, leaving fewer loose lines around the setup.

System Characteristics

• Two-section boom structure for wider desktop microphone placement
• Ball head positioning for precise microphone adjustment
• Internal spring design built into the arm
• Padded C-clamp desk mounting for surfaces up to 2.4″ thick

<